Call us at 0086 18038746275

News Detail

Welcome to our website!

How to adjust the glass patch fittings

2018-05-05 10:22:13

1, positioning, put line
Combination of fixed glass and movable glass door leaf glass door, unified positioning of the line, according to the requirements of the design and construction drawings, release the positioning of the glass door, while determining the position of the door frame.

 

2, the installation box top limit slot
The width of the limiting slot should be two to four millimeters greater than the thickness of the glass, and the slot depth should be ten to twenty millimeters. During the installation, two metal decorative plate edges are drawn from the middle line of the bullet, and then the limiting groove at the top of the door frame is installed according to the edge line, and the depth of the groove in the notch is adjusted through the glue pad.

3, the installation of metal veneer wooden tray
The square wood is fixed on the ground and the metal veneer is glued to the wood with the adhesive.
If the aluminum alloy square tube is used, it can be fixed on the frame column with an aluminum angle, or be fixed on the wooden brick embedded in the ground with a wood screw.

4, install the vertical door frame
The center line of the bullets is used to erect the door frame and then the plywood is used to determine the shape and position of the frame column, and finally the metal decorative surface is covered. When decorating the bag, place the facing seams on the head in the middle door position on both sides of the installation glass.

5, install the glass
The glass sucker is used to suck the thick glass and lift the thick glass plate to the installation position. First insert the upper part of the glass into the limit slot at the top of the door frame, and then put the lower part of the glass on the bottom support.

6, fixed glass
In the bottom of the wooden square on the outside of the nail nails two small wooden bar sandwiched in the middle of the thick glass, in the square bar coated with adhesive and metal veneer stick on the square bar

7. Note glass seal
In the gaps at the top of the top and bottom brackets, and at the gaps between the thick glass and the frame column, inject the glass seal and use a tool to scrape the excess glass glue.

8, glass docking
When the fixed part of the glass door is required to be spliced ​​due to its large size, the seam must have a width of two to three millimeters, and the edge of the glass plate should be chamfered.

9, floor spring installation
Before the installation of the door leaf, the positioning pins of the ground spring and the top surface of the door frame shall be installed and must be coaxial. It is better to use the vertical line inspection to ensure that they are on the same straight line.

10, install the upper and lower patch fittings
Put the upper and lower metal patch fittingss on the upper and lower ends of the glass door respectively. If the door leaf is not high enough, you can insert the wood patch fittingss on the glass bottom of the lower patch fittings.

11, fixed glass patch fittings
After setting the height of the door leaf, insert small wooden strips on both sides of the gap between the glass and the upper and lower door clamps, and inject glass glue into the gap.
 
12, handle installation
Before installation, apply a small amount of glass glue to the part where the handle is inserted into the glass. When the handle is assembled, tighten the root with the glass and tighten the screws to ensure that the handle is not loose. 

We are excellent Chinese manufacturers. Our products, such as Handrail bracket,Handrail bracket, are of excellent quality and affordable. Looking forward to your inquiry。

LEAVE A MESSAGE