Call us at 0086 18038746275

News Detail

Welcome to our website!

Frameless glass door installation process and quality standards

2018-04-16 17:22:38

Frameless glass door installation process and quality standards
Material requirements                                                                                                             
1. The model specifications of the glass door should meet the design requirements, and the frameless glass door patch fittings must be fully furnished and have the factory certificate. 2. The fixed glass plate must be the same as the thickness of the glass door, and must meet the design requirements and have the factory certificate. ( Glass Door Corner patch fittings)
Fixed glass installation:
Use a glass sucker to suck the cut glass with good angle, and then hold the sucker to lift the glass plate, insert it into the limit slot at the top of the door frame, place it on the bottom bracket, and adjust the installation position. The edge of the glass plate is just to cover the stainless steel or other facing seams of the door frame pillars, and then the other side of the wood tray is nailed and the glass plate is fixed on the wooden tray. Apply adhesive to the wooden strips and stick the side stainless steel or other finishes to the wood. (Professional Glass Door Lock patch fittings)
Three dimensions are taken from the upper, middle and lower parts of the mounting position of the fixed glass plate, and the smallest size is the cutting size of the glass plate. If the upper, middle and lower dimensions are the same, the cutting width of the cut glass should be less than the measured size of 2 mm, and the height should be less than the measured size of 4 mm. After the glass plate is cut, it should be chamfered in the periphery with a chamfer width of 2mm.

 

LEAVE A MESSAGE